Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Connect wiring; Refer to Terminal Blocks section.
Set Jumpers; Refer to Jumper Selection section.
Set Dipswitches; Refer to Dipswitch Settings section.
To verify detector operation, perform:
a.
A self test (See Testing the Detector section).
b.
Sensitivity calibration using an external test generator (See
External Test Generator section).
Replace the cover and tighten the cover fixing screws; See Figure 1(A) / 2(B).
TERMINAL BLOCK LAYOUT
Terminal
Block
+12V (RED)
- (BLK)
YEL
GRN
NO
C
NC
TAMPER
SENS
A.OUT
TEST
iv.
Fit the detector using the supplied fixing screws, see
Figure 2(C).
Figure 3: Terminal Block Layout
Description
Power supply positive (+) input voltage
Power supply negative (-) input voltage
Used for data communication with RISCO panels (only for
BUS connection)
Used for data communication with RISCO panels (only for
BUS connection)
Alarm Normally Opened relay output, 24VDC.0.1A
Alarm Common relay output
Alarm Normally Closed relay output, 24VDC.0.1A
N.C. Tamper Switch, 24VDC.0.1A
Remote sensitivity control for lowering vibration sensitivity for
ATM-type dispensers when cash is being disbursed and
internal vibration generated.
GND = Low sensitivity
Not Connected = Reguler sensitivity
Analog signal output: Connect a multimeter/scope or an
analogic tester between the A.OUT and -12V terminals, to
view the noise and signal voltage levels (in parallel to the LED
bar representation). In the absence of vibrations, the voltage
signal is 0V, and it increases as it detects vibrations.
If the voltage measured (in absence of vibrations) doesn't
remain stable but continues to increase, it means that
environmental noise is being captured and therefore the
detector sensitivity must be reduced.
A short between TEST and GND activates the Remote Test
(see Dipswitch Settings 8 and 9).
(Not relevant for BUS mode.)
Seismic Detector
EN
7
Publicité
Table des Matières
