Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INTRODUCTION
The RISCO Seismic Detector is used for the protection against break-in attempts of
vaults, safes, reinforced concrete walls, steel armored cabinets and doors. The
seismic detector monitors the vibration and temperature of a specific surface and
will react to all known types of intruder attacks, such as sledge hammers, diamond
head drills, explosives, hydraulic pressure tools and thermal tools.
The detector can operate both as a regular relay detector connected to any control
panel, or as a BUS accessory when connected to RISCO Group's control panels
via the RS485 BUS, empowering it with unique remote control and diagnostic
capabilities.
The instructions set forth below describe the RISCO seismic detector in Stand
Alone & BUS mode. For BUS installation programming, see RISCO System
installation manuals
Main Features:
Piezo sensor
Low/High temperature detection
Detection range up to 5 meters (16 feet) radius
Tamper protection
Anti drilling shield
Remote sensitivity control
Analogue signal output
Bar graph LED indicator
Remote self test
Stand-alone or RISCO BUS connection
2
Publicité
Table des Matières
