Condensate Drainage - ClimExel DC-20EP Manuel D'utilisation Et D'entretien

Operation
1 - Plug the device into a correctly earthed outlet. (see the information plate on the back of the device)
2 - Press the ON / OFF button to start the dehumidifier. It will start up in continuous dehumidification mode.
3 - Press " HUM " several times in succession to select the relative humidity setting.
4 - Press " SPEED " to chose the air flow rate, high or moderate.
5 - To shut down the dehumidifier, press the " ON / OFF " button again.
6 - Adjust the flap over the air return vent to modify the direction of the air flow.

Condensate drainage

The compressor will stop automatically when the condensate tank is full.
• The 'Tank full' indicator
• An alarm will sound - to stop it, press the ON / OFF button.
• The tank level indicator turns red.
Remove the condensate collection tank by pulling up on the hand grip located at the bottom.
Empty it and then put it back in place, take care to position it correctly: if the tank is incorrectly positioned, the level
indicator will stay red, the 'tank full' indicator will come on and the alarm will sound when the device is started up
again.
To take out the condensate tank,
place your hand on the hand grip and
pull outwards.
flashes.
If the tank is full or incorrectly
positioned, the level indicator will
remain red.
20/24
2009/10 - Indice de révision : A - Code : 0033510