Operating Principle; Siting And Positionning - ClimExel DC-20EP Manuel D'utilisation Et D'entretien

This device lowers the relative humidity in a closed room by drawing air in and over a cold fi n-type radiator (evaporator),
on contact with the cold evaporator, water vapour in the air condenses out and drains by gravity into a holding tank. The
dried and cooled air then passes into a hot fi n-type radiator (the condenser) where it is warmed before being returned
to the room.
For information, this device is designed for the dehumidifi cation of rooms with a volume less than 70m
be modulated depending on the rate at which water vapour is generated and relative humidity to be sustained.
Heated dry air
Air sec réchauffé
Turbine
Motor
Moteur
Condensate
Bac de
collector tank
collecte des
condensats
When choosing the location of the dehumidifi er, abide by the regulations in effect in the country of installation, and
notably those regulations concerning the proximity of outlets and bodies of water.
In France, the standard C15-100 requires that devices with this IP rating be installed further than 3.5m from a body of
water (pool, spa, etc.) and further than 2.4 m from a bath or a sink.
The dehumidifi er should be installed in a location within the room that will allow it to effi ciently extract vapour from the
air (avoid dead zones, corners, etc.). Leave a gap of at least 30 cm around every surface of the machine to allow air to
circulate freely.
This dehumidifi er is fi tted with casters. Switch the device off and empty the condensate holding tank before moving the
machine.

OPERATING PRINCIPLE

Condenser
Condenseur
Evaporator
Evaporateur
Humid air
Air humide
Micro switch
Compressor
Compresseur
SITING AND POSITIONING
16/24
2009/10 - Indice de révision : A - Code : 0033510
, this will need to
3
Condensate
Bac de
collector tank
collecte des
condensats