ClimExel DC-20EP Manuel D'utilisation Et D'entretien page 19

1 - Dehumidification set point setting; continuous, 50%, 60%, 70%, 80%.
2 - Indication of the RH conditions upon start up of the device
Good
RH between 50% and 70%.
RH between 30% and 50% or RH between 70% and 80%.
RH greater than 80%.
3 - Compressor running; if the device is in a defrosting cycle the water drops will flash
Compressor off.
Condensate collection tank full.
4 - Heating indicator (models fitted with this option only): if this button is pressed while the ambient temperature is
less than 25°C, heating starts and the LED lights up. If the ambient temperature is greater than 25°C, both the
heating and the LED will remain off.
NB: The heating element is protected from overheating by a thermostat and a thermal fuse.
5 - UV light indicator (if this option is installed). UV light is bacteriocidal.
6 - 24 hour clock.
7 - Ambient temperature, may be displayed in °C or °F (depending on the country in which the dehumidifier is
purchased, hold down " HUM " for 2 seconds.
8 - Air flow rate: high
50% 60% 70% 80%
2
3
OK Bad
moderate.
1
°F
°C
UV
hr
4 5
6
19/24
2009/10 - Indice de révision : A - Code : 0033510
7
8