Edenwood MIDISOUND Consignes D'utilisation page 26

B
Product usage
NOTE:
• You can only connect the two speakers whilst in Bluetooth mode. Once the
two speakers have been connected in TWS mode, they will automatically
reconnect with each other should they be turned off and back on again.
• You can only connect a MIDISOUND speaker with another MIDISOUND speaker.
You cannot pair the MIDISOUND speaker with other models or brands of
speakers equipped with the TWS function.
• If you change the music source, the TWS function will be disconnected.
• If you want to make a TWS connection with a different speaker, remove previous
connections before attempting to connect with the new speaker.
Operation
WARNING! Before plugging in and switching on the speaker system, make sure
that all the controls are turned off or set to the minimum level.
Music playback
1. Plug the power cable into a mains socket and press the
on the speaker. ON will be displayed on the screen. (Press the
to turn off the speaker, and OFF will appear on the screen.)
2. Connect your audio source as described in the Connections section.
3. To choose the playback source, you can:
• Repeatedly press the SOURCE button to select USB, FM RADIO, LINE IN, AUDIO IN or BT.
OR
• Press the or FM button on the control panel. Whenever a USB stick is connected, the
speaker will immediately enter the relevant mode.
NOTE:
• Check the volume on the speaker and on the external device it is connected to.
4. To control audio playback, you can either use the controls on your external device (if
available) or use the buttons on the speaker's control panel:
Button Mode
MASTER BT/FM
VOLUME knob RADIO/USB
BT/USB
Action
Rotate the knob anticlockwise to lower the volume.
Rotate it clockwise to increase the volume.
The volume range is V00 to V40.
Press to play or pause the track or file.
24 EN
button for 2 seconds to turn
button again at any time