Edenwood MIDISOUND Consignes D'utilisation page 25

B
Product usage
NOTE: If your Bluetooth device was previously connected to another device, remove
that connection before attempting to connect the device to the speaker.
2. Plug the power cable into a mains socket and press the
3. Press either the SOURCE or BT button to select Bluetooth mode. The speaker will
automatically start searching for a new or existing Bluetooth device. When searching for
a new device, NO BT will be displayed.
4. When the Bluetooth device displays the speaker's Bluetooth name, EDENWOOD MIDISOUND,
select the name and confirm the connection. A beep will sound and BT will be displayed
to confirm that the Bluetooth device has been successfully paired.
NOTE:
• If the speaker's Bluetooth name does not appear on your Bluetooth device,
move the devices closer together. If that doesn't work, turn the devices off
and back on again before restarting the pairing process.
• When pairing the devices, make sure they are less than 10 metres apart and
there are no physical obstructions between them.
• Once paired, the devices should remember the connection and you shouldn't
need to pair them again.
Disconnecting a Bluetooth connection
• In Bluetooth mode, press and hold the
connection to disconnect it. NO BT will then be displayed and a beep will sound to confirm
that the devices have been unpaired.
Connecting two speakers in stereo mode (TWS)
You can connect two MIDISOUND speakers to an external audio device via a Bluetooth
connection.
1. Place the speakers close to each other. The speakers must be within 8 meters when the
TWS function is used.
2. Turn on both speakers.
3. Simultaneously press and hold the TWS button on both speakers and the speakers will
enter TWS mode. PARTY SELECT will be displayed on the screen.
4. Use the and
(HOST) and the other a secondary speaker (SLAVE). Once successfully connected, HOST
and SLAVE will be displayed on the main speaker and secondary speaker, respectively.
5. Connect the external Bluetooth device to the speakers via its Bluetooth settings. Choose
the pairing name of the main speaker. When Bluetooth is connected, BT will be displayed
on the main speaker.
6. Press and hold the TWS button on both speakers to exit TWS mode.
buttons on the speakers to make one speaker the main speaker
23
button to turn on the speaker.
button or disable your device's Bluetooth
EN