Side Burner Troubleshooting; Side Burner Maintenance - Weber GENESIS 55826 Mode D'emploi

16

SIDE BURNER TROUBLESHOOTING

PROBLEM
Side Burner does not light.
Flame is low in HIGH position
Push button ignition does not
work.
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact
information on our web site. Log onto www.weber.com

SIDE BURNER MAINTENANCE

WARNING: All gas controls and supply valves
should be in the OFF position.
Make sure black wire is connected between the igniter and electrode.
Make sure white wire is connected between the igniter and grounding
clip.
Spark should be a white/blue color, not yellow.
1) Igniter Wire
2) Ground wire
3) Burner
All manuals and user guides at all-guides.com
CHECK
Is gas supply off?
The excess fl ow safety device, which
is part of the barbecue to cylinder
connection, may have activated.
Is the fuel hose bent or kinked?
Does burner light with a match?
® .
Turn supply on.
To reset the excess fl ow safety device turn all burner control knobs and
the cylinder valve OFF. Disconnect the regulator from the cylinder. Turn
burner control knobs to HIGH. Wait at least 1 minute. Turn burner control
knobs OFF. Reconnect the regulator to the cylinder. Turn cylinder valve
on slowly. Refer to "Lighting Instructions".
Straighten hose.
If match lights burner, check igniter (see below).
Side Burner Grate
Side Burner Cap
Side Burner Ring & Head
Igniter Electrode
Control Knob
(2)
(1)
CURE
(3)
(1)
(2)