Electrical Installation; Assembly - DS Produkte 03460 Mode D'emploi

3. Attach the wall bracket to the wall (see the "Assembly" chapter – "Wall Bracket for
the Remote Control").
4. Insert batteries into the remote control (see the "Inserting / Changing Batteries in the
Remote Control" chapter).

Electrical Installation

DANGER – Risk of Electric Shock!
■ Work on the article may only be carried out when it is disconnected from the power
supply. For this purpose, the fuse for the circuit should be switched off. It is imper-
ative to check whether the connecting cable is disconnected from the power
supply.
Electrical installation may only be carried out by a qualifi ed electrician in compli-
ance with national installation regulations.
Fitted on the article are connections (3) and cables:
Black (Brown)
Blue

Assembly

PLEASE NOTE!
■ The ceiling and the fastening material must be able to bear the weight of the light. If
you are unsure whether the ceiling and the fastening material supplied with the article
is suitable, seek advice from an expert.
■ Before drilling, ensure that there are no pipes or cables behind the intended
drilling point.
Ceiling Light
1. Turn the lamp shade (1) anticlockwise and remove it from the bracket (4).
2. Place the bracket on the ceiling and mark out the three drill holes.
3. Drill holes into the ceiling and place dowels in them.
4. Screw the bracket onto the ceiling.
5. Place the lamp shade on the bracket and turn it clockwise to secure it in place. When
you do this, make sure that the locking lugs on the bracket sit in the recesses which
are provided for them on the lamp shade.
Wall Bracket for Remote Control
1. Place the wall bracket on the wall and mark out the two drill holes.
2. Drill holes into the wall and place dowels in them.
3. Screw the wall bracket onto the wall.
L = live conductor
N = neutral conductor
17 EN