Base (Apwm 031/035) - Miele PWM 920 EL Installation

en - Installation notes
WiFi/LAN inter-
face
Base
(APWM 031/035)
Vapor and suds
venting kit
(APWM 063)
12
The washing machine is equipped with a WiFi/LAN interface for ex-
changing data.
The data interface provided on the LAN connection complies with
SELV (Safety Extra Low Voltage) in accordance with EN 60950. The
LAN connection uses a RJ45 connector in accordance with EIA/
TIA 568-B.
Connected appliances must also comply with SELV.
The washing machine can be installed on a machine base (open or
box base, available as an optional Miele accessory).
Elevating the washing machine gives a better ergonomic working
position when loading or unloading. At the same time it facilitates
the installation of a drain connection.
 The washing machine must be secured to the base immediately
after installation! The base must be secured to the floor!
There is a risk of the washing machine falling off a raised base dur-
ing a spin cycle if it is not secured.
If excessive suds form, suds may escape from the vapor vent. An op-
tional vapor and foam venting kit can be used to remove the foam.