Topdon BT300P Mode D'emploi page 7

2) The device will jump to main menu automatically
after 3 seconds, then select "CHARGING TEST".
MAIN MENU
BATTERY TEST
CRANKING TEST
CHARGING TEST
REVIEW DATA
LANGUAGE
ABOUT
3) Press "ENTER/PRINT" to enter the "RIPPLE TEST"
interface.
CRARGING TEST
PLEASE START ENGINE, PRESS
ENTER TO CONTINUE.
4) Press "ENTER/PRINT" again, or wait for a few seconds
to enter the "CHARGING TEST" interface.
CHARGING TEST
INCREASE SPEED TO
2500 R/MIN , KEEP IT
FOR 5 SECONDS . PRESS
ENTER TO CONTINUE
5) The tester prompts the operator to "Increase RPM
to 2500r/min and keep it 5 seconds". Press "ENTER/
PRINT" to get the test result:
EN I 12
RIPPLE TEST
12.98V
For 12V Battery
CHARGING TEST
CHARGING V
LOADED V
UNLOADED V
RIPPLE V
For 24V Battery
CHARGING TEST
CHARGING V
LOADED V
UNLOADED V
RIPPLE V
Reference Table (for 12V battery)
Status Battery Voltage
≥15.0V
Headlamps
& A/C OFF 13.2V~15.0V
(Depress
Accelerator) 12.8V~13.2V
<12.8V
Reference Table (for 24V battery)
Status Battery Voltage
≥30.0V
Headlamps
27.0V~30.0V
& A/C OFF
(Depress
25.6V~27.0V
Accelerator)
<25.6V
LOW
12.20V
12.87V
5mV
NORMAL
27.9V
27.9V
50mV
Conclusion
CHARGING HIGH
CHARGING NORMAL
CHARGING LOW
NO OUTPUT
Conclusion
CHARGING HIGH
CHARGING NORMAL
CHARGING LOW
NO OUTPUT
EN I 13