Topdon BT300P Mode D'emploi page 6

2. Cranking Test (12V&24V)
2.1 Before Test
The engine and all other accessory loads must be OFF
before test in order to have accurate results.
2.2 Steps
1) The RED (+) Positive Battery Clamp is connected
to the (+) positive battery terminal, and the BLACK
(-) Negative Battery Clamp is connected to the (-)
negative battery terminal. Ensure that the clamps
have a firm, secure grip on the battery terminals for
accurate results.
2) The device will jump to main menu automatically
after 3 seconds, then select "CRANKING TEST":
MAIN MENU
BATTERY TEST
CRANKING TEST
CHARGING TEST
REVIEW DATA
LANGUAGE
ABOUT
3) Press "ENTER/PRINT" to enter the "CRANKING TEST"
interface, start the engine according to the prompts.
CRANKING TEST
PLEASE START ENGINE
4) The result will show as below:
EN I 10
30
For 12V Battery
CRANKING TEST
CRANKING V NORMAL
CRANKING TIME
1599ms
10.33 V
For 24V Battery
CRANKING TEST
CRANKING V NORMAL
CRANKING TIME
2400ms
22.54 V
3. Charging Test (12V&24V)
3.1 Before Test
The engine must be ON during test in order to have
results. Ensure all electrical accessories and devices
remain in the OFF state.
* Turning ON/OFF any electrical accessories in the
vehicle during the test will affect the accuracy of the test
result.
3.2 Steps
1) The RED (+) Positive Battery Clamp is connected
to the (+) positive battery terminal, and the BLACK
(-) Negative Battery Clamp is connected to the (-)
negative battery terminal. Ensure that the clamps
have a firm, secure grip on the battery terminals for
accurate results.
EN I 11