Wiring Information (Pour Le Royaume-Uni Uniquement) - Brother HL-7050 Série Guide De L'utilisateur

Imprimante laser
Masquer les pouces Voir aussi pour HL-7050 Série:
Table des Matières

Publicité

Wiring information (pour le Royaume-Uni uniquement)

If the mains plug that is supplied with this printer is not suitable for your plug socket,
remove the plug from the mains lead and fit an appropriate three-pin plug. If the
replacement plug needs a fuse, fit the same fuse as the original.
If a moulded plug comes off the mains lead, you should destroy it because a plug
with cut wires is dangerous if it is put in a live plug socket. Do not leave it where a
child might find it!
If you need to replace the plug fuse, fit a fuse that is approved by ASTA to BS1362
with the same rating as the original fuse.
Always replace the fuse cover. Never use a plug that does not have a cover.
Warning - This printer must be earthed.
The wires in the mains lead are coloured in line with the following code :
Green and Yellow: Earth
Blue:
Brown:
The colours of the wires in the mains lead of this printer may not match the coloured
markings identifying the terminals in your plug.
If you need to fit a different plug, you should do the following.
Remove a bit of the outer cover of the lead, taking care not to damage the coloured
insulation of the wires inside.
Cut each of the three wires to the appropriate length. If you can, leave the green and
yellow wire longer than the others so that, if the lead is pulled out of the plug, the
green and yellow wire will be the last to disconnect.
Remove a short section of the coloured insulation to expose the wires.
The wire which is coloured green and yellow must be connected to the terminal in
the plug which is marked with the letter "E" or the safety earth symbol
green or green and yellow.
The wire, which is coloured blue, must be connected to the terminal, which is
marked with the letter "N" or coloured black or blue.
The wire, which is coloured brown, must be connected to the terminal, which is
marked with the letter "L" or coloured red or brown.
The outer cover of the lead must be secured inside the plug. The coloured wires
should not hang out of the plug.
xii
Important
Neutral
Live
, or coloured

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Hl-7050n

Table des Matières