Télécharger Imprimer la page

Wiring Information (Pour Le Royaume-Uni Uniquement); Important - Brother HL-2400C Série Guide De L'utilisateur

Publicité

Wiring Information (Pour le Royaume-Uni uniquement)

If the mains plug supplied with this printer is not suitable for your socket
outlet, remove the plug from the mains cord and fit an appropriate three
pin plug. If the replacement plug is intended to take a fuse then fit the
same rating fuse as the original.
If a moulded plug is severed from the mains cord then it should be
destroyed because a plug with cut wires is dangerous if engaged in a live
socket outlet. Do not leave it where a child might find it!
In the event of replacing the plug fuse, fit a fuse approved by ASTA to
BS1362 with the same rating as the original fuse.
Always replace the fuse cover. Never use a plug with the cover omitted.
WARNING - THIS PRINTER MUST BE EARTHED
The wires in the mains cord are coloured in accordance with the
following code :
GREEN AND YELLOW
BLUE
BROWN
The colours of the wires in the mains lead of this printer may not
correspond with the coloured markings identifying the terminals in your
plug.
If you need to fit a different plug, proceed as follows.
Remove a length of the cord outer sheath, taking care not to damage the
coloured insulation of the wires inside.
Cut each of the three wires to the appropriate length. If the construction
of the plug permits, leave the green and yellow wire longer than the
others so that, in the event that the cord is pulled out of the plug, the
green and yellow wire will be the last to disconnect.
Remove a short section of the coloured insulation to expose the wires.
The wire which is coloured green and yellow must be connected to the
terminal in the plug which is marked with the letter "E" or by the safety
earth symbol
The wire which is coloured blue must be connected to the terminal which
is marked with the letter "N" or coloured black or blue.
The wire which is coloured brown must be connected to the terminal
which is marked with the letter "L" or coloured red or brown.
The outer sheath of the cord must be secured inside the plug. The
coloured wires should not hang out of the plug.
xvi

Important

: EARTH
: NEUTRAL
: LIVE
, or coloured green or green and yellow.

Publicité

loading