Kongskilde KDC 4000 Plus Manuel page 15

Installation of inner screen
The inner screen is installed by guiding it around the
screen drum, and turning the drum to enable the screen
ends to be clipsed together.
Installation of outer screen
Outer screen replacement is most easily done from the
right-hand side of the cleaner (viewed from the inlet
end).
The outer screen is installed by placing the screen end
opposite of the quick release clamps under the cleaner.
Thereafter the u profile is hooked onto the cross bar
on the drum, in the screen end with the quick release
clamps. The drum is now turned, enabling the screen
clamps to be clipsed together as shown.
Adjustment of aspiration cleaner
1. First open the damper (A) completely by squeezing
the spring and turning the damper.
A
2. Adjust the guiding plates by means of the handle
(B), to ensure that the crop layer is equally high
in both sides of the cleaner. This may be checked
through the inspection windows (1) on the sides.
1
D
15