Relay Connection; Setup; Operating Position - Eaton Ex ResistTel IP2 Mode D'emploi

2.1.9

Relay Connection

The telephone has two relays with each a single switch at its proposal.
Figure 5: Terminal Assignment Relays of the Explosion proof VoIP
Telephone ExResistTel IP2 (Exposition: Relay not active)
terminal
18 (relay 1) base contact relay 1
19 (relay 1) not used
20 (relay 1) switching contact relay 1
21 (relay 2) base contact relay 2
22 (relay 2) not used
23 (relay 2) switching contact relay 2
Table 2: Terminals of the Relays of the Explosion proof VoIP Telephone
ExResistTel IP2
The terminals of the relays are below a cover to be protected against random
touching. The terminals must be protected again carefully with the cover after
connecting.

2.2 Setup

The configuration of the
of the normal ResistTel IP2 /
the telephone.

2.3 Operating Position

The telephone may be mounted hanging vertically on a wall or hanging vertically on
a mounting plate.
ExResistTel IP2 follows as described in the operating manual
IP152. The manual can be found on the CD attached to
18 / 21
20 / 23
description
13