SELFSAT SNIPE 2 R Manuel Utilisateur page 19

F. Cable holder installation 2
F-1
Controller cable, receiver cable, cable holder and gland are required
F-2
Set up required parts as above picture
F-3
Place the assembled cable holder inside the tape
marking and drill three(3) of 2mm holes
F-5
Apply silicone around cable holder and on the
top of screws for waterproof
F-4
Fix cable holder on the vehicle roof with
three(3) of M4 x 20 screws on drill holes made
F-6
Connect cables to the ports of the antenna ,
remove friction tape and tidy silicone before dry
ENGLISH - 18