Installing Receptacle Module For Use With A Spool Gun (Optional) - Hobart Welding Products BETA-MIG 2510 Manuel Du Propriétaire

3-3. Installing Receptacle Module For Use With A Spool Gun (Optional)

1
4
3
2
All manuals and user guides at all-guides.com
1 Knockout Panel
Pierce front panel label at corners
of knockout and follow groves in
front panel. The knockout is held in
place by a thin metal section half-
way down each side. Be sure to cut
label across metal sections, before
removing knockout, to avoid tear-
ing the label.
2 Module
3 Plug PLG9
4 Receptacle RC2
Locate receptacle RC2 in unit wir-
ing harness. Connect plug PLG9 to
RC2. Slide module in and secure
with supplied screws.
Tools Needed:
ST-801 869-A
OM-194 430 Page 19