Olympia CC 310.4 Mode D'emploi page 16

Paper Shredder CC 310.4 / MC 306.2
Operating the Paper Shredder
Automatic Shredding
The paper infeed is equipped with sensors so that it can start up automatically
when material is inserted. The device draws the material in and stops automatical­
ly when shredding is completed and no further material is fed in.
Turn the rotary knob to AUTO.
The Power LED lights up green and the device is ready for use. If the Pow­
er LED does not light up green, please check that the waste bin has been
installed correctly.
ATTENTION!
• Risk of property damage through material jam!
Pay attention to the maximum capacity of the paper infeed
(refer to Technical Data).
In the event of a material jam, the device stops until the material has been
removed from the paper infeed (refer to Reverse Running and Clearing
Residual Material).
Reverse Running
Reverse operation is necessary to clear material which jams.
1. Turn the rotary knob to REV.
2. The cutting mechanism runs in reverse continuously and the (jammed) material
is released.
CAUTION!
• Risk of injury through the sharp edges of the cutting mech­
3. Pull the material out of the cutting mechanism.
4. If reverse running does not clear the material jam completely, please follow the
instructions in Chapter Clearing Residual Material.
16
anism!
Never reach into the cutting mechanism.
Keep fingers and hands away from the paper infeed.
Gi