ims PRO COMBISPOT 230V Mode D'emploi page 15

Translation of the original instructions
New generation dent puller 2 in 1. The COMBISPOT 230 is a dent puller for steel and aluminium car bodies. Cost-ef-
fectiveness and time saving is provided by this method of repair by pulling single-point and multi-points without
disassembly.
This device contains 2 dent-pullers with two control panels:
A steel dent puller
Generator with multi-function guns and an earth cable.
- The gun with trigger connects to terminal no.5 ; the
command cable connects to terminal no.4
- The automatic gun (no trigger) connects to terrminal
no.6
- The earth cable is fixed on position no. 7
A- Steel position (fig. I)
• Connect the machine to an appropriate power supply.
Nb: COMBISPOT 230 has, in addition to the power connector, a connector to command the torch trigger
- Connect the latter if you wish to start by using the trigger
- Disconnect it if you prefer use the generator with automatic start (see OPERATION section)
• Press the « on/off » key (6)
• The indicators switch on for few seconds then the machine displays:
- Tool, n°1 by default, (star welding or dent pulling clamp).
- Power level, n°5 by default, (setting adapted for 0.8mm steel sheets).
• To change the power level, press the + or – keys (3). Keep the desired key pressed to scroll through the levels auto-
matically.
• The available power levels allow the straightening of sheets of varying thickness (fig. I-2).
• To change the tool used with the gun, press the tool selection key (I-3);
The tool indicator will blink for 5 seconds. During this time, it is possible to change the tool number by pressing
the + or - keys (3).
Available tools (fig. I-3)
1 Straightening using the star hammer, or dent pulling
clamp
2 Crimped welding wire or rings for straightening.
3 Impact reduction with specific copper tip.
4 Carbon electrode for tempering.
Start-up:
With use of the trigger
The COMBISPOT 230 features 2 start-up settings:
- Manual, by using the trigger (Attach the power and command connectors)
- Automatic, see below. (Attach only the power connector)
In manual mode, connect the power and trigger command cables.
The automatic mode is disabled, only a pressure on the trigger will generate the arc.
The switch allows activating or deactivating the trigger gun.
Without use of the trigger
The machine is able to generate the welding arc automatically.
The generator will automatically detect the electrical contact and generate the welding arc in less than 1 second. To
create a new arc, stop the contact with the gun tip for at least ½ second and establish contact again to form another
arc.
IMS COMBISPOT 230 V
An aluminium dent puller
Capacitor discharge generator, with one gun equipped
with an earth adapter (3 brass terminals)
- The gun connects to terminal no.2
- The command cable connects to terminal no.1
- The earth cable connects to terminal no.3
5 Welding rivets for side rods
6 Welding rings for fixing vehicle body.
7 Welding studs for vehicle body and connecting beams
EN
15