KS Tools 550.1810 Notice D'utilisation page 5

(Caution: 24V exit for the 24V model). When the jump starter is used with an inverter, it can
operate appliances normally powered by 230V (optional).
USED AS PORTABLE WELDING MACHINE:
The jumpstarter 12/24V can also be used for indoors or outdoors welding without being plugged.
It makes it possible to weld in 24V during 12 to 15 minutes (based on a fully charged unit) with
the welding gun delivered in option, provided with tubular wire. Caution: do always use a
helmet and safety goggles for all work of welding
1. Check the charge level of the jumpstarter, it must be fully charged before use.
2. Select the 24V voltage.
3. Connect the welding gun in the socket on the unit.
4. Connect the negative clamp to the ground.
5. Regulate the welding speed with the variator according to your comfort, and start welding by
pressing the trigger of the gun.
6. Once the welding work achieved, unplug the gun and recharge imperatively the unit with the
supplied automatic charger and put the commutator in 12V position, or plug the connector in the
12V socket.
7. Welding amperage 160A and decreasing.
7. WARRANTY
The warranty on the jump starter depends on the conditions granted by your retailer. The
manufacturer shall have no liability whatsoever at any time for any personal injury or property
damage or for any special, indirect or consequential damages at any time for any kind howsoever
arising.
Please dispose of packaging for the product in a responsible manner. It is suitable for recycling.
Help to protect the environment, take the packaging to the local amenity tip and place into the
appropriate recycling bin.
Never dispose of electrical equipment or batteries in with your domestic waste. If your supplier
offers a disposal facility, please use it or alternatively use your local amenity tip and dispose in a
correct manner. This will allow recycling of raw materials and help protect the environment.
8. TROUBLE SHOOTING
PROBLEM
• One or two LED's come on, charger is
plugged on for 24 hours and there is no
change in status of other Leds.
• Charger works well but the jump starter is
not being charged.
• No LED's come on, but when the charger
is plugged into the jump starter all the LED's
come on.
• The jump starter is fully charged but has
no power.
SOLUTION
• Check if charger is charging. Charger should be
warm. Also check if the fuse inside the cigar lighter
plug of the charger is not defective.
• Possible defective battery or faulty breaker. Try
using a device (for example a 12V light) with a cigar
lighter plug to see if it works. Should it work,
breaker is OK and the battery is the problem.
• Defective battery. Cause: intense use, without
allowing a cool down period; see also operating
instructions.
• Check where the cable is connected to the jaws
on the jump starter's clamps and make sure they are
properly connected to the battery terminal.