KS Tools 550.1810 Notice D'utilisation page 4

Charging times depending on model and charger:
12V appliance with automatic charger LESA.5A 0.6A
12V appliance with automatic charger LESA.6A 1.5A
12V, 12/24V appliance with 2 batteries and automatic charger LESA.6A 1.5A
12V, 12/24V appliance with 2 batteries and automatic charger 12V-4A
24V appliance with 2 batteries and automatic charger 24V-2A
the red light of the charger is extinguished or becomes green (LESA.5A, LESA.6A), or when all
LED's are flashing (12V-4A, 24V-2A) the battery is fully charged.
These data are non-contractual and can be subjected to changes, please for more information
take contact with your retailer.
When the Jump starter is not in use, always keep it connected to the supplied automatic charger!
6. OPERATING INSTRUCTIONS
USED AS AN EMERGENCY JUMP STARTER:
1. Always shield eyes.
2. If you have a 12/24V unit, make sure that the switch commutator is on "OFF" or that the
connector is unplugged (depending on model).
3. Connect the positive (red) clamp to the positive terminal.
4. Connect the negative (black) clamp to the negative terminal of the engine or to the frame of
the vehicle (ground). Make sure cables are not in the path of moving belts or fans, etc.
5. If you have a 12/24V unit, choose the voltage with the switch commutator or with the
connector 12V or 24V. Stay clear of battery and engine starter while jump-starting and make sure
that it cannot fall in the engine of the vehicle.
6. Once started, put the switch commutator on "OFF" or unplug the connector (12/24V
unit), and disconnect the black (negative) clamp first.
7. Then disconnect the red (positive) clamp.
8. Store immediately both clamps in their respective placing.
9. Put the jump starter in charge with the supplied automatic charger.
IMPORTANT: Should the vehicle refuse to start within 10 seconds, have the jump starter cool
down for 3 minutes before attempting to start the vehicle again. Otherwise severe damage to the
unit may occur. (Start attempts always need to be very short).
NOTE: A defective battery may refuse to accept the current from the jump starter. This may
be the reason that the vehicle refuses to start.
USED AS MEMORY SAVER FOR VEHICLES:
The jump starter can be an essential tool for all those who replace automobile batteries. Most
vehicles have some type of electronic component with memory, such as radios, phones, clocks,
computers, etc. However memories can be saved, if the supplied charging cable is plugged from
the jump starter to the cigar lighter outlet on the vehicle. Like this, valuable information will not
get lost.
IMPORTANT: For some car models ignition must be switched on, using ignition key.
MULTI PURPOSE POWER SUPPLY:
The jump starter is also suitable as a portable power source for all 12Vdc accessories equipped
with a male cigar lighter plug. The 12V outlet has an automatic overload protection of 20A
28H maxi.
12H maxi.
22H maxi.
08H maxi.
16H maxi. When