Important Safety Instructions; Technical Specifications - KS Tools 550.1810 Notice D'utilisation

Dear customer,
KS TOOLS thanks you for you trust and for buying one of its products.
In this manual, you will find every safety warnings and precautions, operating, maintenance and
cleaning procedures. Please, read it carefully before using the product. Keep this manual and invoice
in a safe and dry place for future reference.
The manufacturer cannot be held responsible for damage or injury caused by improper use of this
appliance.
IMPORTANT NOTE: Before first use charge the jump starter with the supplied charger for at least 12
hours.

1. IMPORTANT SAFETY INSTRUCTIONS

1. Wear goggles during each use.
2. Use of an attachment not recommended or sold by the jump starter's manufacturer, may result in
a risk of damage to the unit, or injury to personnel.
3. When using the charger or charging cable, pull on the plug and never on the wire when
disconnecting.
4. Do not recharge the jump starter with a damaged plug or cord. Replace the broken part
immediately (see point 2).
5. The jump starter can be used under any weather condition (rain, snow, hot or cold weather).
6. Do not submerge in water.
7. Never bring the red and the black clamp into contact or allow them to contact the same piece of
metal to avoid any short-circuit.
8. Do not operate in an explosive environment and / or with flammables such as gasoline, gas etc.
9. Do not try to repair the jump starter yourself when defective, but have it repaired always by your
distributor (otherwise warranty will not be given).
10. Never leave the jump starter too long without recharging it. Severe damages caused by this are
probably not repairable.
IMPORTANT: When the engine starter is not in use, recharge it every 3 months with the supplied
accessories. However it's recommended to always keep it connected to the automatic charger.

2. TECHNICAL SPECIFICATIONS

1. Type of battery: sealed, non-spillable, lead acid battery with solid electrolyte (AGM) according
the I.A.T.A standards.
2. Automatic charger with smart circuit which allows leaving the unit in charge continuously
without damage.
3. 12V exit (cigar lighter socket), protected with an automatic reset breaker of 20A, to be
connected to all sorts of 12V accessories or to charge the jump starter (Caution: 24V exit for the
24V model)
4. Fully isolated clamps and copper cables (super flexible).
5. Test button and leds, or digital or analogue display, to check the charge of the battery from
25% to 100%. For a complete test, press test button for 10 seconds.
6. Surge protection.