Speedaire 45UZ55 Instructions D'utilisation Et Manuel De Pièces page 4

4) The reel is supplied with a hose guide roller bracket. The bracket position may be
changed depending on the reel mounting position. Figure 2 shows "Typical Mounting
Positions". If bracket position needs to be changed, do the following:
(1) Pull out some hose or cable and let reel latch.
(2) Remove the bolts that attach the guide roller bracket to the support post.
(3) Rotate guide roller bracket to correct position, replace bolts and tighten.
Floor
OPERATION
1. Check reel for correct operation by slowly pulling out hose or cable. A "clicking" noise will
be heard every half revolution of the drum.
2. To latch the reel, pull out the hose or cable and allow it to retract after hearing the first
second or third "click".
3. To unlatch, slowly pull out the hose or cable until the "clicking" noise stops, then let hose
or cable retract until the hose or bumper block rests against the cable guide.
4. When over loading, the supplementary protector will cut off automatically, then push the
button until restore.
5. Periodically check the hose condition for wear or damage, and check the swivel fitting for
leakage. Replace any worn, damaged, or leaking parts.
Note: To avoid damage to the reel, always hold on to the cable while it is rewinding.
E4
Wall
Figure 2 Typical Mounting Positions
Ceiling