Technical Details - Speedaire 45UZ55 Instructions D'utilisation Et Manuel De Pièces

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

TECHNICAL DETAILS

Specification of Cord (3C / 125V)
Item No.
AWG
Ampere
45UZ55
14
13A
SAFETY PRECAUTIONS
GENERAL SAFETY RULES
WARNING: Read carefully and understand all instructions before operating.
WARNING: The warnings, cautions, and instructions discussed in this instruction
manual cannot cover all possible conditions or situations that could occur. It must be
understood by the operator that common sense and caution are factors which cannot be
built into this product, but must be supplied by the operator.
1) Ensure that only the qualified electrician installs/services this cable reel.
2) Ensure that power supply voltage does not exceed maximum voltage rating of reel.
3) Ensure that reel is properly installed before connecting to power supply.
4) Ensure that all electrical power is removed from reel before servicing.
5) Check for frayed and broken wires before each use.
6) When pulling electrical cable from the reel always grasp the electrical cable itself, not the
work device.
7) Remove power from the reel immediately when any malfunction occurs.
8) Never remove, tamper with or cut out the safety devices fitted by the manufacture.
9) Do not use the reel in damp or wet conditions. Keep the work area clean.
10) Exposure of skin directly to pressurized air, or fluids can could result in severe bodily
injury.
11) Not for use in hazardous locations or above hazardous location use.
INSTALLATION
1) The reel must be installed in premises conforming to current regulation and standards
covering electrical systems and work environments.
2) Secure the reel to the wall and the ceiling according to the installation diagrams. Use
anchor screws or suitable screws which must be fitted in the holes in the brackets.
3) If hose or bumper block adjustment is required, pull out some hose or cable from reel
and allow to latch at desired length. Loosen bumper bolts and slide bumper block to a
position close to the hose or cable guide. Tighten bumper bolts, and unlatch the reel.
Figure 1 Technical Details
Type
Outlet
Plug Type Length
SJT
S1
NEMA 5-15P
Specification of Hose
(3/8" / 300Psi)
Material
Length
25"
NBR/SBR
25'
Packing
NW/GW
16.9/18.4kgs
E3

Publicité

Table des Matières
loading

Table des Matières