Kenwood TM-281A Mode D'emploi page 46

While in Channel Display mode, you cannot activate the
following functions:
• VFO Mode
• VFO Scan
• Call/VFO Scan
• MHz Scan
• Scan Direction
• Memory Store
• Memory to VFO Transfer
• Memory to Memory Transfer
• Clear Memory Channel
7
• VFO Reset
• Full Reset
• 1 MHz Step
• Selection for Tone and Selective Call
• Auto Simplex Checker
• Menu Mode
To recover normal operation, turn the transceiver power
OFF and press [REV]+[
Note:
To enter the Channel Display Mode, you must have at least one
◆
Memory Channel that contains data.
If the Memory Channel contains a Memory Name, the Memory
◆
Name is displayed in place of "CH".
38
] (Power) again.