Programming An Offset; Selecting An Offset Direction; Selecting An Offset Frequency - Kenwood TM-281A Mode D'emploi

PROGRAMMING AN OFFSET

You must first select an amateur radio repeater
downlink frequency as described in "S
F ".
REQUENCY
S O D
ELECTING AN FFSET IRECTION
Select whether the transmit frequency will be higher (+)
or lower (–) than the receive frequency.
1 Press [F], [MENU] and turn the Tuning control to
select Menu No. 5 (SFT).
2 Press [MENU] and turn the Tuning control to select "+"
or "–".
3 Press [MENU] to store the setting or any other key to
cancel.
4 Press any key other than [MENU] to exit Menu Mode.
• "+" or "–" appears above the frequency, indicating which
offset direction is selected.
If the offset transmit frequency falls outside the allowable
range, transmission is inhibited. In this case, adjust the
reception frequency so that the transmit frequency is
within the band limits or change the offset direction.
Note: While using an odd-split memory channel or transmitting, you
cannot change the offset direction.
S
To access a repeater which requires an odd-split
O frequency pair, change the offset frequency from the
ELECTING AN FFSET
default which is used by most repeaters. The default
offset frequency is 600 kHz.
1 Press [F], [MENU] and turn the Tuning control to
2 Press [MENU] and turn the Tuning control to select
3 Press [MENU] to store the setting or any other key to
4 Press any key other than [MENU] to exit Menu Mode.
O F
ELECTING AN FFSET REQUENCY
select Menu No. 10 (OFFSET).
the appropriate offset frequency.
• The selectable range is from 0.00 MHz to 69.95 MHz in
steps of 50 kHz.
cancel.
Note: After changing the offset frequency, the new offset frequency
will also be used by Automatic Repeater Offset.
6
23