Speedaire 437J24A Mode D'emploi page 9

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

MAINTENANCE AND INSPECTION INSTRUCTION
Ratchet / Spring Inspection
When the hose is pulled out, the "clicking" sound should be heard.
After the "clicking" noise is heard, the rotating drum will be locked in place by the ratchet device
and the hose will not be rewound.
If the clicking sound is not heard, the hose should rewind automatically
The inspection should proceed as above periodically.
● When the ratchet device does not work, it should be replaced.
● When the hose is not rewound automatically, the hose reel should be replaced.
Leakage Inspection
Regarding the media (fluid) which is used for the hose reel, checking for leaks should be
done periodically.
After taking out the hose, fully apply the soapy water on the connected point.
(Such as housing or shaft).
If the connected point is bubbling up, the user should suspect phenomenon of leakage.
● When a leak occurs, the sealing of the housing or shaft should be replaced.
● When a leak occurs because of hose damage, the hose should be replaced.
Swivel Seal Replacement
● Remove the hose from the swivel.
● Remove the snap ring with dedicated pliers.
● Remove the swivel by pulling it towards user.
● Attach the new swivel to the reel.
● Attach the snap ring to the new swivel with the dedicated pliers.
● Connect the input hose to the new swivel.
Any repairs or replacements must be done by a
qualified person or authorized service center only.
An inspection should be conducted periodically.
Also the maintenance record should be updated
periodically. When a problem occurs, it should be
repaired after the pressure has been released.
7

Publicité

Table des Matières
loading

Table des Matières