IKEA LAGAN Mode D'emploi page 14

ENGLISH
Problem
The lamp does not
work.
The compressor oper-
ates continually.
Water flows on the rear
plate of the refrigera-
tor.
Water flows into the re-
frigerator.
Water flows on the
ground.
The temperature in the
appliance is too low/
high.
If your appliance is still not working proper-
ly after making the above checks, contact
the After Sales Centre. You can find the list
at the end of this manual.
Replacing the lamp
Caution! Disconnect the plug from the
mains socket.
1. Pull outwards the hook of the lamp cov-
er.
Possible cause
The lamp is defective.
The temperature is not set
correctly.
The door is not closed cor-
rectly.
The door has been opened
too frequently.
The product temperature is
too high.
The room temperature is too
high.
During the automatic defrost-
ing process, frost defrosts on
the rear plate.
The water outlet is clogged.
Products prevent that water
flows into the water collector.
The melting water outlet does
not flow in the evaporative
tray above the compressor.
The temperature regulator is
not set correctly.
Solution
Refer to "Replacing the lamp".
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open
longer than necessary.
Let the product temperature
decrease to room temperature
before storage.
Decrease the room tempera-
ture.
This is correct.
Clean the water outlet.
Make sure that products do
not touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Set a higher/lower tempera-
ture.
14