Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
14
Mashing and Boiling Process
First clean all the parts of your brewing equipment, it is very important for
1
satisfactory results.
2
Fit the Bazooka filter to the tap inlet.
3
Assemble the false bottom, and position it inside the water tank.
Fill with water, and heat up to 67°C. (All temperatures and timings are for
4
reference only).
5
Add the grain, then use a suitable paddle to stir it gently.
When the mashing temperature is reached, after adding the ingredients, turn
6
on the timer, normally the mashing lead time is 60mins.
7
After mashing is complete, drain out the wort, then sparge it with water at 78c.
Set a boiling temperature for a 1 hour boil. 2500W is mainly for reaching the
8
target temperature, when target temperature is reached, please switch it to
1600W.
After boiling, cooling the wort down to 20c as fast as possible. Then transfer
9
the wort to your fermentation vessel.
Note: Please adjust the power according to your experiences and needs, as recipes
do vary. This model does not have a circulation system, so the bottom part water
temperature and the top part water temperature may be different.
Publicité
Table des Matières
