Foppapedretti Misterchef Mode D'emploi page 16

12
A
A
13
ASSEMBLING THE PADDING
Place the padding on the seat.
Insert the plastic ring, fixed to the end of the strap, through the slots in the fabric and the corresponding slots in the seat shell.
Rotate the ring into a vertical position, on the outer side of the backrest. Check that it has locked correctly.
Insert the plastic ring, fixed to the end of the lap belt, through the slots in the fabric and the corresponding slots in the seat
shell.
Rotate the ring into a vertical position, on the outer side of the backrest. Check that it has locked correctly.
Insert the plastic ring, fixed to the end of the leg separator belt, through the slots in the fabric and the corresponding slots in
the seat shell.
Rotate the ring into a horizontal position, on the underneath of the backrest. Check that it has locked correctly.
• ENGLISH •
All manuals and user guides at all-guides.com
ASSEMBLY
12. CLOSING THE HIGH CHAIR
CAUTION: Make sure that the child, and any other children, are at a safe
distance away when carrying out these steps. Make sure that the moving
parts of the HIGH CHAIR do not come into contact with the child's body
during these steps.
CAUTION: If in use, remove the tray before closing by attaching it to the
back of the frame using the two hooks. See step 9.
Adjust the backrest and the leg rest to a vertical position.
To reduce its dimensions, we recommend that you adjust the seat to the
lowest position; see step 6.
CLOSING: Stand behind the highchair. Press the "A" buttons located
above the hinges and, at the same time, bring together the highchair
legs (Fig. 12) until you hear the click indicating that they are locked in
the closed position.
REMOVING THE PADDING FOR WASHING
Rotate the plastic locking ring of the safety harness "straps"
and "lap belt" on the rear side of the backrest (a), and
remove the harness by pulling it from the inner side of the
seat, through the slots in the seat shell and padding.
Rotate the plastic locking ring of the leg separator on the
underneath of the seat and remove the belt by pulling it from
the inner side of the seat, through the slots in the seat shell
and padding.
Unclip the press stud that secures the fabric at the sides to
the armrest (b).
Remove the lining from the seat (C).
16