Canon MF244dw Mode D'emploi page 11

NOTE
• You cannot connect both the wired LAN and wireless
LAN at the same time. In addition, the machine is set to
the "Wired LAN" by default.
• When you connect to an unsecured network environment,
your personal information could be disclosed to third
parties. Please use caution.
• If you connect through a LAN in the offi ce, contact your
network administrator.
Checking the Router
Select the connection method to the wireless LAN. Select from
the following two methods depending on the router (access
point) that you are using.
●
There is a button.
This machine supports WPS
(Wi-Fi Protected Setup). You
can easily set up if your router
(access point) has a button,
and if the mark is on the
router.
If you are not sure whether or not your router supports WPS,
please see the manual included in the product, or contact the
product manufacturer.
●
There is no button.
If there is no button on your
router (access point), you
may manually select SSID and
complete the settings. In this
case, you need to remember
SSID and network key of your
router (access point).
See "1 Check SSID or Network
Key for a Wireless LAN Router/
Access Point. " (P.12) to learn how to fi nd out your SSID and
network key.
To set up with the WPS PIN code method/To set up
manually:
User's Guide "Connecting to a Wireless LAN"
Setting Wireless LAN
Push Button Mode
1
Press .
2
Select <Network Settings>, and then press
3
Select <Wireless LAN Settings>, and then press
If a screen appears asking whether to enable the wireless
LAN, select <Yes>, and then press
4
Read the message that is displayed, and then press
.
5
6
7
8
.
.
.
Select <WPS Push Button Mode>, and then press
.
Wireless LAN Settings
SSID Settings
WPS Push Button Mode
WPS PIN Code Mode
Power Save Mode
Select <Yes>, and then press
Press and hold* the button until the lamp lights or
blinks.
You should press the WPS button within 2 minutes after
you select <Yes> in step 6.
* The time that you should hold the button may vary depending
on the router you are using.
Wait approximately 2 minutes after the connection.
IP address is set during this period of time.
If an error message appears:
Press to close the screen, check whether or not the
network key is correct, and then retry the settings. If the
access point cannot be detected even after retrying,
see the following.
User's Guide "When an Error Message Appears"
When checking the network connection:
You can check if the machine is properly connected to
the network by using a computer that is connected to the
network.
User's Guide "Viewing Network Settings"
To set IP address manually:
User's Guide "Connecting to a Wireless LAN"
.
En
11