Installation; Required Tools - Electrolux Kenmore Elite 253.4474 Serie Guide D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation

Required Tools

You will need the following tools:
This Use & Care Guide provides general installation and
operating instructions for your model. We recommend
using a service or kitchen contracting professional to install
your refrigerator. Use the refrigerator only as instructed
in this Use & Care Guide. Before starting the refrigerator,
follow these important first steps.
Location
Choose a place that is near a grounded, non-GFCI,
electrical outlet. Do Not use an extension cord or an
adapter plug.
If possible, place the refrigerator out of direct sunlight
and away from the range, dishwasher, or other heat
sources.
The refrigerator must be installed on a floor that is
level and strong enough to support a fully loaded
refrigerator.
CAUTION
Do not install the refrigerator where the temperature
will drop below 55°F (13°C) or rise above 110°F (43°C).
The compressor will not be able to maintain proper
temperatures inside the refrigerator.
Do not block the kick plate on the lower front of your
refrigerator. Sufficient air circulation is essential for the
proper operation of your refrigerator.
Installation
Allow the following clearances for ease of installation,
proper air circulation, and plumbing and electrical
connections:
Sides & Top
Back
NOTE
If your refrigerator is placed with the door hinge side
against a wall, you may have to allow additional space
so the door can be opened wider.
7
3/8 inch (9.5 mm)
1 inch (25.4 mm)
3/8" (10mm)
Refrigerator
3/8"
(10mm)

Publicité

Table des Matières
loading

Table des Matières