JBL on stage Guide D'installation page 6

on stage Easy Setup Guide
on stage specifications*
Step 1. Unpack on stage, wall adaptor,
iPod adaptors and cable. Read this
instruction sheet completely.
Frequency range: 100Hz–20kHz
Power consumption: 20W maximum
Transducers: (2) 1-inch full range per
channel
Amplifier output power: 6 Wrms per
channel
Dimensions:
6.75" (17.1 cm) diameter
1.5" (3.8 cm) tall
Weight: 1.1 pound = 0.5 kg
Sound quality can be affected by the
amount of file compression.
USE ONLY JBL approved power supplies
listed on the product label.
6
If you have any questions, or need further assistance, please visit www.JBL.com.
*These specifications are subject to change without notice.
Troubleshooting
Step 2. Choose correct iPod
adaptor type. Press iPod adaptor
into on stage.
Symptom
No sound from on stage
speaker system.
Clicking/Ticking noise from
speakers
Step 3. Plug power adaptor into on
stage. Connect adaptor to wall out-
let.
Possible problem
No power to system.
Power adapter plug not
inserted correctly.
No volume or low volume.
Input source is low.
Incorrect power supply
plugged into A/C jack or
firewire port.
Step 4. If using iPod with bottom
connector, dock iPod into front
connector of on stage.
Solution
Ensure power supply is connected to live
power source and properly connected to on
stage. Please note: When on stage is pow-
ered, a green power LED should illuminate.
Touch the volume "Up" ( + ) pad on the volume
control to unmute and/or increase the system
volume level.
Note: Touching the volume "Down" ( - ) pad
lowers the system volume. Touching both ( + )
and ( - ) volume control pads at the same time
will mute the system.
Increase the volume level on the audio source
device.
Disconect non-JBL power supply.