ThermoUp FLOOR Mode D'emploi page 27

FLOOR HEATER THERMOUP FLOOR/LED/LED PLUS
FLOOR HEATER THERMOUP
FLOOR/LED/LED PLUS
Heater design
Power button
Cord socket
Power cord (1.8m)
What's Included in the set
1. Heater
2. Detachable electric power cord for heater
3. Lighting control panel
4. Operating manual and warranty card
The heater is equipped with a control panel with
an individual radio code. The rst time the heater
is switched on, the heater must be set up to use the
remote control.
Installation and connection
1. Unbox the device.
2. Place it on the oor or any other at surface.
3. Plug the removable power cord into the appropriate
part on the device, then plug the power cord into an
electrical outlet.
4. Press the heater power button to put the device into
operation.
5. Set the required power of the instrument using the
regulator.
6
Scheme 1. Heater ThermoUp oor
Setting a new control panel
1. Switch off the power to the heater using the button on the side
panel of the heater: when switched off, it does not glow.
2. In the upper left corner of the control panel, press and hold
the «Power on» button.
3. Turn on the power to the heater with the button on its side
panel.
4. After 3-4 seconds, the heater will con rm the reception of
the control panel signals with short beeps or by ashing the
backlight.
5. Release the button on the control panel. The setting is
complete.
If you have replaced the remote control, the setting procedure
must be repeated.
Thermoelement (glass)
Aluminium base