Vision Fitness S70 Montage page 6

• Position the COVERS (12) over the rear incline arm bracket and secure each cover in
place with 4 BOLTS (T).
5
• Position the COVER (13) over the elevation bracket and secure with 2 BOLTS (S).
• Take the REAR BASE FRAME COVERS (14) and pull apart to separate and slide
around the bottom of the incline arm. Snap the three tabs down to set in place.
• Begin pedaling to power up the unit or plug the power cord into the power socket in
the front of the unit. Plug the other end of the cord into the wall outlet. Make sure the
power switches at the bottom of the unit and on the back of the console are in the on
position.
BLACK BAG
Description
S M5x15L Phillips Head Bolt
T M5x25L Phillips Head Bolt
12
T
14
6
Qty
2
8
13
S
YELLOW BAG
6
S70
Description
U M5x12L Round Head Bolt
V M8x12L Socket Head Bolt
W 8.5x12.8x1.3T Safety Washer
X End Cap
X
U
V
W
U
V
Y
YELLOW BAG
NO.4
S700E
Description
NO.3
Y M4x10L Round Head Bolt
NO.2-2
V M8x12L Socket Head Bolt
V
W 8.5x12.8x1.3T Safety Washer
NO.2-1
W
NO.2
NO.1
Y
NO.2-2
V
NO.2-1
W
Y
• Remove the wire tie from the data cable
and console mast.
Qty
• Remove the four console mounting
bolts from the backside of the CONSOLE
(15) with the screwdriver. Connect the
2
heart rate wires coming from the mast
4
to the heart rate wires coming from the
4
bottom of the CONSOLE (15). Insert the
2
data cable through the bottom of the
CONSOLE (15) and plug into the board.
Pull any extra wire down into the console
mast. Secure CONSOLE (15) to the
15
bracket using the 4 SOCKET BOLTS (V)
and 4 WASHERS .
• Connect 9-volt battery. Position the REAR
CONSOLE COVER (16) on the back of the
CONSOLE (15) and secure with the four
16
bolts removed earlier. Tighten with the
screwdriver.
X
• Insert cupholder and attach with 2 BOLTS
15
(U). Snap the END CAPS (X) in place.
16
W
Qty
15
7
4
4
Y
NO.4
NO.3
15
16
NO.2
NO.1
16