Vision Fitness S70 Montage page 4

NOTE: A second person will be helpful to complete this step.
1
• Slide the CONSOLE MAST BOOT (3) onto the console mast.
• Locate the DATA CABLE (2) and ELEVATION MOTOR CONNECTOR (1) in the main
frame recess. Make sure they are pulled out of the opening and can be easily plugged
in when the mast is inserted.
• Set the console mast into the console mast frame bracket. Secure the front of the
mast to the frame bracket with 4 SOCKET HEAD BOLTS (B), 4 LOCK WASHERS (C),
and 4 FLAT WASHERS (D). Tighten with the 6MM T-SHAPED WRENCH. Secure the
sides of the console mast to the console mast bracket with 1 HEX BOLT (A) to each
side. Tighten with a 13MM WRENCH.
• Plug in the ELEVATION MOTOR CABLE (4) to the cable socket sitting in the frame
bracket.
• Wrap the wire tie that comes out of the bottom of the console mast around the DATA
CABLE (2) that exits the top of the frame. Feed the wire tie and DATA CABLE (2) up
through the channel in the side of the mast while pulling the wire tie straight up
through the top of the mast.
• Slide the boot down over the frame and snap in place.
ORANGE BAG
Description
A M8x12L Hex Bolt
B M8x20L Socket Head
C Bolt
D M8 Lock Washer
8.2x16x1.6T Washer
A
4
Qty
2
46.8N.m/ 34.6 ft-Ib 4
4
4
3
4
2
1
B
C
D
• Lift the left INCLINE ARM (5) and insert the bearing end of the SUSPENSION ARM (6)
into the bracket of the incline arm. From the outside, insert a HEX BOLT (E) through
2
the bracket and SUSPENSION ARM (6). Secure with a lock WASHER (F) and NUT (G).
Tighten with 2 19MM WRENCHES. Make sure hardware is tight.
• Repeat this step on the right side.
BLUE BAG
Description
E M12x95L Hex Bolt 80N.m/59 ft-Ib
F M12 Lock Washer
G M12 Hex Nut
G
5
Qty
2
2
2
E
F
6