Vision Fitness S70 Montage page 5

Masquer les pouces Voir aussi pour S70:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 9
NOTE: A second person will be helpful to complete this step.
3
• Place the left CONNECTION ARM (7) over the left incline arm bracket and connect
with 2 SOCKET HEAD BOLTS (H). Tighten only a few turns with the 8MM L-SHAPED
WRENCH.
• Insert the pin on the front flange of the CONNECTION ARM (7) to the hole in the
console mast ELEVATION BRACKET (8).
• Repeat these steps on the right side.
• When the pins of both connection arms are seated in the holes of the console mast
elevation bracket lift the entire assembly slightly to line up the screw holes. Insert
4 SOCKET HEAD BOLTS (K) with WASHERS (J) through these holes. Secure with
a WASHER (J) and NYLON NUT (I) to each bolt. Tighten with the 6MM L-SHAPED
WRENCH and 13MM WRENCH.
• Go back and completely tighten the screws that connect the connection arms to the
incline arms with the 8MM L-SHAPED WRENCH.
PINK BAG
Description
H
M10x65L Socket Head Bolt
I
M8 Nylon Nut
J
8.2x16x1.6T Washer
K
M8x30L Socket Head Bolt
H
Qty
46.8N.m/ 34.6 ft-Ib
4
4
8
4
7
8
J
K
• Connect the remote toggle cables. Place the left DUAL-ACTION ARM (9) on the left
ROTATION HOUSING (10) and secure in place with 4 BOLTS (Q) and lock WASHERS
2 4
(P). Tighten with the 6MM L-SHAPED WRENCH.
• Line up the rotation housing cover over the ROTATION HOUSING (10) and attach
using 2 PHILLIPS BOLTS (R).
• Slide the LINK ARM (11) between the flanges of the DUAL-ACTION ARM BRACKET.
Insert a SOCKET HEAD BOLT (N) through the hole to connect the brackets. Secure
with a NYLON NUT (M). Tighten with the 10MM WRENCH and 5MM L-SHAPED
WRENCH.
• Set the dual-action cover in place over the connection bracket. Place the NUT (L) into
the recess on the inside cover. Insert a BOLT (O) through the outside hole and tighten
to the nut with a screwdriver.
• Repeat these steps on the right side.
GREEN BAGS
Description
L
M5 Hex Nut
M
M8 Nylon Nut
N
M8x50L Socket Head Bolt
O
M5x50L Phillips Head Bolt
P
M8 Lock Washer
Q
M8x20L Socket Head Bolt
R
M5x12L Phillips Head Bolt
P
Q
I
R
J
Qty
2
2
46.8N.m/ 34.6 ft-Ib
2
2
8
8
4
10
9
L
M
O
N
11
5

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

S700e

Table des Matières