Location; Water Supply Connections - Scotsman Ice DXN Série Manuel D'utilisation Et D'entretien

Scotsman products are designed and
manufactured according to the highest
safety and quality standards; this
particular equipment
designed to be installed within the
following operating limits:
Ambient temperature 10°C
Water temperature
Water hardness
Water pressure
Voltage
Any use of the machine outside these
limits or outdoor will automatically
forfeit your warranty.
Should the mains water you use fail to
meet the above‐mentioned parameters
we recommend that you use an
external water treatment device.
Scotsman reserves the right to make
changes at any time, without warning
and with no obligation.
The sound level generated by the
equipment when in operation is lower
than 70 dB(A).
Location
It is important that the machine
installation location ensures that there
is enough clearance on the outside to
allow access during maintenance
operations and that there is a free
space of at least 15 cm on all sides for
has been
Min Max
38°C
10°C 35°C
10 °fH 20°fH
0.1 Mpa 0.6 Mpa
‐10% +10%
proper ventilation; where possible,
avoid hot and dusty locations. Make
sure that the equipment is properly
levelled with the counter onto which it
rests.
This machine is NOT suitable for
outdoor use and NOT suitable for
installation in an area where a water
jet could be used for cleaning.
WARNING: the air blow‐out grills
located on the rear and left side
panel must always be unobstructed.
Never place any objects that may
obstruct them.
Do not locate multiple portable
socket‐outlets or portable power
supplies at the rear of the appliance.
Water supply connections
At time of installation replace the
old/used water hoses with the new
ones supplied in the machine.
All water supply connections must be
carried out according to the highest
standards and in compliance with local
regulations.
Water supply
Use drinkable, clean and cold water.
Water flows into the machine through
the rubber hose connected to the 3/4"
male fitting located on the rear side of
the equipment. A water shut‐off valve
(tap) should be installed near the
machine installation location.
7