Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
S
Drill mounting holes at the marks
on the floor and wall.
S
Install the faucet and drain to the
lavatory according to the
manufacturer's instructions.
NOTE:
Do not fully tighten slip-joint
drain connections at this time.
S
Position the pedestal mounting
hole over the hole in the floor.
S
Secure the pedestal to the floor
with the wood screw and washer.
Tighten the screw until it is snug.
CAUTION: Risk
of
damage.
Do
not
Overtightening may cause damage
to the product.
S
Set the lavatory on the hanger and
pedestal, and level the lavatory
using leveling pads.
S
Secure the lavatory to the wall with
lag bolts and washers.
CAUTION: Risk
of
damage. Do not overtighten lag
bolts. Overtightening may cause
damage to the product.
S
Connect and tighten the trap to
drain. Connect the hot and cold
water supplies to the faucet.
Kohler Co., Kohler, WI U.S.A.
product
overtighten.
Finish Wall
product
3
Pedestal
Wood Screw
Washer
Lavatory
Washer
Lag Bolt
Pedestal
A
1011307-2-
Publicité
Table des Matières
