Control Panel - Electrolux ENN28600 Notice D'utilisation

Masquer les pouces Voir aussi pour ENN28600:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4 electrolux
• Make sure that the mains plug is accessi-
ble after the installation of the appliance.
• Connect to potable water supply only.
Service
• Any electrical work required to do the
servicing of the appliance should be car-
ried out by a qualified electrician or com-
petent person.
• This product must be serviced by an au-
thorized Service Centre, and only genu-
ine spare parts must be used.
Environment Protection
This appliance does not contain gasses
which could damage the ozone layer,

CONTROL PANEL

1
Pilot Light
2
Temperature Regulator
3
Action Freeze light
4
Action Freeze switch
Switching on
Insert the plug into the wall socket.
Turn the Temperature Regulator clockwise
to a medium setting.
The Pilot Light will light up.
Switching off
To turn off the appliance, turn the Tempera-
ture Regulator to the "O" position.
The Pilot Light will switch off.
Temperature regulation
The temperature is automatically regulated.
To operate the appliance, proceed as fol-
lows:
• turn the Temperature Regulator toward
lower settings to obtain the minimum
coldness.
• turn the Temperature Regulator toward
higher settings to obtain the maximum
coldness.
4) If a water connection is foreseen.
in either its refrigerant circuit or insula-
tion materials. The appliance shall not
4)
be discarded together with the urban
refuse and rubbish. The insulation foam
contains flammable gases: the appli-
ance shall be disposed according to
the applicable regulations to obtain
from your local authorities. Avoid dam-
aging the cooling unit, especially at the
rear near the heat exchanger. The ma-
terials used on this appliance marked
by the symbol
1
2
3
4
A medium setting is generally the most
suitable.
However, the exact setting should be chos-
en keeping in mind that the temperature in-
side the appliance depends on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
Action Freeze function
You can activate the Action Freeze function
by pressing the Action Freeze switch.
The Action Freeze light will light up.
Important! This function stops
automatically after 52 hours.
It is possible to deactivate the function at
any time by pressing Action Freeze switch.
The Action Freeze light will switch off.
are recyclable.

Publicité

Table des Matières
loading

Table des Matières