Tilt Adjustment - DURABLE 5089 Mode D'emploi

EN
English
– Insert the cable into the enclosed cable clamps (11) as shown.
– Secure the cable clamps (11) on the swivel arm (4) as shown.
Operation
– Place the monitor in the desired position.
Rotating range
▶ see figure 10 for # 5089
▶ see figure 21 for # 5090

Tilt adjustment

▶ see figure 10
▶ see figure 21
– If the monitor tilts independently or is very difficult to tilt, adjust
the braking effect using the screw (14) in the joint.
Swivel range for # 5090
▶ see figure 21
WARNING!
Risk of product damage!
Do not move the swivel arm against the resistance in the
swivel joint.
Height adjustment for # 5090
▶ see figure 22
– Adjust the brake/spring effect of the height adjustment with the
adjusting screw (4) in such a way that the swivel arm with the
monitor attached neither sags, nor springs upwards.
WARNING!
Risk of product damage!
Do
construction-dependent resistance.
32
not move the swivel arm against this