Variable Speed Control - Black & Decker KA330E Instructions D'origine

ENGLISH
damage, wear and ageing. Replace the
extension cable if damaged or defective.
When using a cable reel, always unwind
the cable completely. Use of an extension
cable not suitable for the power input of
the tool or which is damaged or defective
may result in a risk of fire and electric
shock.
Features
This tool includes some or all of the follow-
ing features.
1. On/off switch
2. Dust collection canister
3. Dust collection canister lock
4. Sanding base
5. Paper clamp lever
6. Variable speed control knob
Assembly
Warning! Before assembly, make sure that
the tool is switched off and unplugged.
Fitting sanding sheets (fig. A &
B - D)
Warning! Never use the tool without a sand-
ing sheet or accessory in place.
Note: For best results always use punched
sand paper. If your sand paper is not
punched then the dust collection canister
will not work.
Fitting sanding sheets with nylon
loops (fig. A)
• Make sure that the tool is switched off
and unplugged.
• Press the sheet firmly and evenly onto the
sanding base (4), making sure that the
holes in the sheet line up with the holes in
the base.
Fitting regular sanding sheets
(fig. B - D)
• Make sure that the tool is switched off
and unplugged.
• Soften the sanding sheet by rubbing its
non-abrasive side over the edge of a
worktop.
• Press the paper clamp levers (5)
upwards to release them from the
retaining grooves and open the paper
clamps by pressing them down (fig. B).
• Place the sheet onto the sanding base
8
All manuals and user guides at all-guides.com
(Original instructions)
(4), making sure that the holes in the
sheet line up with the holes in the base
(fig. C).
• Insert the edge of the sanding sheet into
the front paper clamp as shown (fig. D).
• Press the front paper clamp lever (5)
downwards and locate it in the retaining
groove.
• While keeping a slight tension on the
sheet, insert the rear edge of the sheet
into the rear paper clamp.
• Press the rear paper clamp lever (5)
downwards and locate it in the retaining
groove.
Fitting and removing the dust
collection canister (fig. E & F)
• Turn the dust collection canister lock (3)
anti-clockwise.
• Carefully slide out the dust collection
canister (2).
• Lift the filter (7) out and empty the
contents of the dust collection canister.
The lid of the filter can be gently tapped
to remove any particles that cling or is
can be brushed with a soft clean brush.
• Insert the filter (7) into the dust collection
canister (2).
• Slide the dust collection canister (2) into
the tool.
• Lock the dust collection canister (3) into
place by turning the dust collection
canister lock clockwise..
Note: Monitor the the dust collection canis-
ter (2) at regular intervals. Empty the dust
collection canister fequently to ensure
the best efficiency of your tool.
Use
Warning! Let the tool work at its own pace.
Do not overload.

Variable speed control

The variable speed control allows you to
adapt the speed of the tool to the work-
piece material.
• Set the control knob (6) to the desired
setting. Use a high speed for wood,
medium speed for veneer and
synthetics and low speed for acrylic glass,
non-ferrous metals and for removing
paints.