NEC Flat Professional Serie Mode D'emploi page 11

Controls cont.
IPM ™ System Off Mode:
NOTE: For standard systems and graphics boards, keep the factory setting
at ENABLE.
EdgeLock ™ Control: Operating your monitor at a non-standard timing may
cause images to appear darker than normal or have color distortion. Use of the
EdgeLock control will adjust images to their normal state.
Video Detect: Selects the method of video detection when more than one com-
puter is connected.
NONE: The Monitor will not search the other video input port unless the
monitor is turned on.
FIRST DETECT: The video input has to be switched to "FIRST DETECT" mode.
When current video input signal is not present, then the monitor searches for a
video signal from the other video input port. If the video signal is present in the
other port, then the monitor switches the video source input port to the new
found video source automatically. The monitor will not look for other video
signals while the current video source is present.
LAST DETECT: The video input has to be switched to the "LAST DETECT" mode.
When the monitor is displaying a signal from the current source and a new
secondary source is supplied to the monitor, then the monitor will automatically
switch to the new video source. When current video input signal is not present,
then the monitor searches for a video signal from the other video input port. If
the video signal is present in the other port, then the monitor switches the video
source input port to the new found video source automatically. The monitor will
not look for other video signals while the current video source is present.
DVI Selection: This function selects the DVI input mode. When the DVI selection
has been changed, you must restart your computer.
DIGITAL: DVI digital input is available.
ANALOG: DVI analog input is available.
7A811011.WPC
Enable: The IPM System works
normally and all stages of
energy savings are utilized.
Disable: The Off Mode of the IPM
System is not used.
9
11 5/18/00, 12:26 PM