Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 61
4.
Place the other end of garden hose into a floor drain.
Check to see that the hose lies flat and is in the drain.
Make sure the hose end that gose to the drain is on a lower
level than the hose end that connects to the dehumidifier.
The hose should not be kinked or pinched.
5.Reinstall bucket.
NOTES:
To use the bucket without the garden hose, remove the
.
the garden hose Then reinstall bucket.
The bucket must be installed and properly aligned for the
the dehumidifier to operate with or without a garden hose
connected.
Option 3 PUMP-Drain (for Pump function model only)
This feature can help to pump water horizontally or vertically with a 16 feet
hose included. You can also pump water to a floor drain, out a window
or anywhere you think suitable.
NOTE: You must connect the drain hose (with connector B) to drain
hose connector A before pressing Pump button. If the pump does
not function properly, see "Trouble shooting" for direction.
1. To connect drain hose to the unit.
Push drain hose connector B into the connector A.
When your dehumidifier is operating normally, you may hear
sounds such as:
Compressor sounds, which may be loud, This is normal.
Air movement from the fan.
2. To disconnect drain hose.
Push drain hose connector A in, and then pull connector B out.
NOTE:If the unit will not used for a certain period of time,
please unplug the water plug as shown in the picture and
drain the dehumidifier completely.
IMPORTANT: Before using, please ensure the water
plug is tightly plugged, otherwise hose drainage option
and pump drainage option will not work properly.

Normal Sounds

Pump sounds, which may be loud, is normal.
Clicking sounds when the dehumidifier or compressor turns
off and on.
9
water plug

Publicité

Table des Matières
loading

Table des Matières