Hisense DH-25K4HDL Consignes D'utilisation Et D'installation page 6

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 61
If the bucket is not in position remove the bucket and
.
reinstall it Make sure the bucket fits all the way into the
dehumidifier and the light is off or dehumidifier
run.
Fan Speed
1.Press FAN to select fan speed.
2.Choose Low, High or Auto.
LOW- Will reach the desired humidity setting slower with
lower sound level .
HIGH-Will reach the desired humidity setting faster.
AUTO-Will provide the maximum humidity control by automatically
adjusting the fan speed.
Desired Humidity
1.Press
MODE
to select the desired humidity setting.
2.Choose Auto Dry, Continuous or Manual Set.
AUTO DRY: The dehumidifier will operate in dry mode only.
Auto Fan Speed is set automatically. The Desired Humidity
is set to 50% automatically.
CONTINUOUS: The dehumidifier will operated
continuously.
The Fan Speed can be adjusted. The Desired Humidity can
not be adjusted. The LED display will show the room humidity
level.
MANUAL SET:The dehumidifier will operate at the
selected fan speed and desired humidity.If the humidity
levels of the room is higher than the desired humidity
setting, the compressor will turn on. If the humidity
level of the room is lower than the desired humidity
setting, the compressor will turn off.
NOTE:
The deice will turn off the compressor if a low temperature
condition occurs. Pressing the MODE button or the plus or
minus button will not increase or decrease the amount of
moisture removed. When the de-icer senses then correct
operating temperature, the compressor will cycle back on.
Power
Press POWER to turn on or turn off the dehumitifier.
,
,
will not
Humidity Level
1.
Press the Plus or Minus button to activate the humidity setting
program. Digits in the digital display will flash.
2.
Press the Plus or Minus button again to set your desired
humidity.
3.
Digital display will stop flashing five seconds after setting.
Room humidity will be displayed.
NOTE:
Humidity can only be adjusted manually in Manual Set mode.
In Continuous and Auto Dry mode, humidity level is set automatically.
Digital Display
Display shows relative humidity or time (depending on setting).
1.When the dehumidifier operates in Manual Set modes,the
display shows the relative humidity of the room.
2.When the timer is selected, the display shows the time when
the dehumidifier will turn on or turn off, depending on the setting.
3.For heat function model, when the dehumidier operates
in heat mode, the display shows the room temperature.
NOTE:
The humidity displayed is only for reference. For accurate humidity,
please check a hygrometer.
Timer
To set Timer for a 30-minute to 24-hour delay before the
dehumidifier is turned off (the dehumidifier must be On):
1. Press TIMER. Timer indicator light will come on, the Display
will flash. The display will show remaining time before the
dehumidifier will turn off.
6
.
.

Publicité

Table des Matières
loading

Table des Matières