Important - Hisense DH-25K4HDL Consignes D'utilisation Et D'installation

2. Press the Plus or Minus button to change the delay time,
from 30 minutes to 24 hours.
To set Timer to turn on the dehumidifier, with previous
setting:
1. Turn off the dehumidifier.
2. Press TIMER. Timer indicator light will flash. The display will
show remaining time before the dehumiditier will turn on.
3. Press the Plus or Minus button to change the delay time,
from 30 minutes to 24 hours.
To clear the Timer delay program:
Dehumiditier can be either on or off.
NOTE:
1. Press TIMER once after it has been programmed. Display
will show remaining time.
2. While the display is showing the remaining time, press TIMER
again. Timer indicator light will turn off.
To see the remaining time.
Press TIMER once after it has been programmed. Display will
show remaining time.
Clean Filter
1. CLEAN FILTER indicator light is on, remove, clean
When
and replace air filter. See "Cleaning the Air Filter".
2. Press CLEAN FILTER
air filter to reset the filter monitor.
NOTE:
When the light is on. it will remain on for 360 hours or
until you press CLEAN FILTER. After 180 hours, it will
turn off automatically.
Heat (for heating function model only)
NOTE: The compressor does not operate in the Heat mode.
1. Press HEAT to select the Heat mode.
2.Press FAN to select the fan speed. see "Fan Speed".
3.Press the Plus or Minus button to select the temperature.
4.To turn off the Heat mode, press MANUAL SET or
POWER.
after cleaning and replacing the
NOTES:
■ If the room temperature is above 86
will turn off. The fan keeps running.
If the room temperature is
■
temperature, the Heat mode will turn off.
■ If the room temperature is
temperature, the Heat will turn on.
Change between ºF and ºC .
Press both the Plus and Minus button at same time to change
from ºF to ºC or from ºC to ºF.
Pump (for Pump function model only)
This feature can help to pump water horizontally or vertically
with a 16 feet hose included. You can also pump water to a
drain, out a window or anywhere you think suitable.

IMPORTANT:

You must connect the drain hose to the unit before pressing
Pump button. see "Pump drain" for connecting direction.
1. Press PUMP to activate the pump system for active drainage.
2. Once the pump button is pressed, the pump light will switch on.
NOTE:
■
If the pump light flashes, it means that the pump is not functioning
properly.
■ If the drain hose is not correctly connected to the unit or is bent,
the pump light will flash and the pump system will not work.
See "Trouble shooting" for direction.
Ionizer (for Ionizer function model only)
1. Press IONIZER to start or stop the ionizer.
2. Once the IONIZER button is pressed the ionzier light will
switch on.
7
ºF (30 ºC) ,
the
2 ºF (1 ºC)
higher than the selected
2 ºF (1 ºC)
lower than the selected
P
H m
eat ode