Setting The Controls - Hisense DH-25K4HDL Consignes D'utilisation Et D'installation

Control Panel
Control Type1
AUTO DRY
CONTIN UOUS
MANUAL SET
TIMER MODE
Control Type2 (HEAT)
AUTO DRY
CONTIN UOUS
MANUAL SET
HEAT TIMER MODE
Control Type3 (PUMP)
AUTO DRY
CONTIN UOUS
MANUAL SET
TIMER MODE
Control Type4 (IONIZER)
AUTO DRY
CONTIN UOUS
MANUAL SET
TIMER MODE
NOTES:
The control panel of your model may differ from the one shown above.
Energy star sign used in North America only.
PUMP, HEAT, IONIZER button may not be displayed on
the panel, if your model does not have these functions.
DEHUMIDIFIER USE

Setting the Controls

AUTO
HIGH EMPTY BUCKET
LOW
POWER FAN CLEAN FILTER
AUTO
EMPTY BUCKET
HIGH
LOW
POWER FAN CLEAN FILTER
AUTO
HIGH EMPTY BUCKET
LOW
P
POWER FAN CLEAN FILTER PUMP
AUTO
HIGH EMPTY BUCKET
LOW
POWER FAN CLEAN FILTER IONI ZER
/
Starting Stopping the Dehumidifier
NOTES:
Before turning on the dehumidifier be sure that the bucket
■
is empty and fits all the way into the dehumidifier.
Each time you unplug the dehumidifier or power is interrupted,
■ ■
the controls will return to the previous settings when power is
restored.
■ ■
Humidity displayed is between
90% Relative Humidity.
Humidity can be adjusted between
■
80% Relative Humidity.
Plug into a grounded outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
1.Plug into a properly grounded outlet.
2.Press POWER to turn on the dehumidifier.
3.Press FAN to choose the fan speed.
4.Press MODE to choose the mode.
5.Press the plus or minus button to choose the level of
humidity.
6.Press POWER to turn off the dehumidifier.
NOTE: The dehumidifier will retain your last settings .
EMPTY BUCKET Light
,
If this light is on the dehumidifier is not running. This light
indicates that you need to check:
If the bucket is full empty and reinstall bucket.
■
5
,
30% Relative Humidity
30% Relative Humidity
Electrical Shock Hazard
WARNING
,
and
and