Remote Control; Operation Mode - turbionaire REVIGO10 Manuel D'instructions

REMOTE CONTROL

Ventilating your room
- Press MODE button repeatedly until the LED of FAN operation lights up. In ventilation mode
the room air is circulated, but not cooled.
- Press SPEED button repeatedly to select the fan speed as desired.
Drying your room
Press MODE button on the control panel or remote control, the LED of DRY operation lights up.
The fan speed is unable to select. User should connect the hose to the drain outlet at the
bottom of the unit.
Note: In this mode, the fan speed switches over to low speed and cannot be selected.
Sleep Mode（this function can only be used with a remote control)
The sleep mode can be activated when in cool mode and heat mode.
In Cool Mode :
After 1 hour the preset temperature is increased by 1 ℃, after another hour the preset
temperature will again be increased by 1 ℃.
TIMER Setting (1 h - 24 h)
The timer has two ways of operation:
To turn OFF (When POWER On) - Press Timer key to turn on the timer function - Press Up/
Down repeatedly to set the delay OFF time.
To turn ON (When POWER Off) - Press Timer key to turn on the timer function - Press Up/
Down repeatedly to set the delay ON time.
Cance TIMER - Press Up/Down repeatedly until the LED shows '00'.
Note: when press POWER will also exit the timer setting.
Automatic Defrost - At low room temperatures, frost may buildup at the evaporator
during operation. The unit will automatically start defrosting and the POWER LED
blinking. The defrost control sequence is as follows:
SETTINGS
Start-up and Shutdown
- Press POWER to turn REVIGO 10 on.
- The unit runs in in FAN as default.
- Press MODE button to select the desired operation mode.
- Press POWER again to turn off the power.

OPERATION MODE

REVIGO 10 has four operation modes: Cool, Dry, Fan, Sleep.
Cooling your room - Select COOL Mode to lower the temperatur
e in your room.
- Press MODE button repeatedly until the LED of COOL operation lights
up.
- Press Up/Down button to adjust the temperature which is displayed
on the screen. The temperature can be set between 16℃ and 32℃.
- Press SPEED button repeatedly until the desired fan speed indicator
lights up.
- To control the direction of the air flow horizontally, please adjust the
inner louver by hand.
Note: The air conditioner stops if the room temperature is lower than
selected temperature.
12