Dell PowerEdge C8000 Mise En Route page 26

Connecting the Server Enclosure to a Rack PDU
WARNING:
the PDU is energized. Turn off the PDU breaker switches to avoid potentially
serious or fatal electrical shock. Move the PDU A, B, and C breaker switches to
the "OFF" position.
1 Unlock the cable cover ‚.
2 Rotate the cover — back and away from the PDU.
3 Attach the server enclosure(s) power cables to the PDU power bus bar.
NOTE:
The PDU device supports a maximum of five PowerEdge C8000 server
enclosures depending on the system configuration and power budget.
To connect a single server enclosure to the PDU:
Secure the three black power cable lugs ‚ to the top power bus bar
a
(GND) with the three screws ˜.
Secure the three yellow power cable lugs — to the bottom power bus
b
bar with the three screws ˜.
24
Getting Started With Your System
Do not connect or disconnect power cables to the PDU device while
2
1